Web Toolbar by Wibiya

Author Topic: A5 RAP-4 Flexiair issues.  (Read 1860 times)

0 Members and 1 Guest are viewing this topic.

Offline kamokenny

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
  • I love RAP4
A5 RAP-4 Flexiair issues.
« on: November 17, 2012, 09:32:56 AM »
Hi Guys, I decided to keep modding my main A5 and I chose the RAP4 flexiair.


 As a few internet searches suggested issues with the flexible hose I went for the end cap only and added braided hose and elbows.this kit is a cut-down version of what they intend to use on the tamco magfed upgrade. MK5 INTERNAL AIR THROUGH UPGRADE KIT. THIS is the cause of my issues.

IT HAS BEEN A DRAMA!!! even had the part replaced. The main problem was that the badly tapped and drilled air exit hole was coming into the end cap above the o-ring, preventing a seal.


Managed to work around this by Loctiting in a CO2 inline on/off. Now it's all airtight and ready to go...... But now i hear a very small new hissing. turns out it's from where they have plugged the old exit port. you can see in this picture where I've put a drop of loctite in hope that may improve the seal.

IMG_1524.jpg photo by kiwikenny | Photobucket

If this doesn't work I have no clue what to do. It's getting expensive returning the parts to rap4 from New Zealand

Offline robomaniac

  • Russian RAP4 fan
  • Jr. Member
  • **
  • Posts: 69
  • Karma: +2/-0
  • Gender: Male
    • my web
Re: A5 RAP-4 Flexiair issues.
« Reply #1 on: November 19, 2012, 06:54:24 AM »
try to reassemble it again and check all o-rings, maybe you will find idea to your problem
tactical magfed paintball forever!!!!